Researchers – Dan Zhao and Simone Fabiano – at the Laboratory of Organic Electronics at Linköping University, have created a thermoelectric organic transistor, which can be controlled by a change in temperature. A temperature rise of a single degree is sufficient to cause a detectable current modulation in the transistor. The heat-driven transistor opens up the possibility of many new applications such as detecting small temperature differences, and using functional medical dressings in which the healing process can be monitored.This research team is the first in the world to present a transistor, that is controlled by a heat signal instead of an electrical signal. According to them, it is also possible to produce circuits controlled by the heat present in infrared light for use in heat cameras and other applications. The high sensitivity to heat is 100 times greater than traditional thermoelectric materials, means that a single connector from the heat-sensitive electrolyte, which acts as sensor, to the transistor circuit is sufficient. One sensor can be combined with one transistor to create a “smart pixel.”A matrix of smart pixels can then be used, for example, instead of the sensors that are currently used to detect infrared radiation in heat cameras. With more developments, the new technology can potentially enable a new heat camera in mobile phones at a low cost, since the materials required are neither expensive, rare nor hazardous.The heat-driven transistor builds on research that led to production of a supercapacitor charged by the sun’s rays a year ago. In the capacitor, heat is converted to electricity, which can then be stored in the capacitor until it is needed.The researchers at the Laboratory of Organic Electronics had searched among conducting polymers and produced a liquid electrolyte with a 100 times greater ability to convert a temperature gradient to electric voltage than the electrolytes previously used. The liquid electrolyte consists of ions and conducting polymer molecules. The positively charged ions are small and move rapidly, while the negatively charged polymer molecules are large and heavy. When one side is heated, the small ions move rapidly towards the cold side and a voltage difference arises.Dan Zhao and Simone Fabiano have shown, after many hours in the laboratory, that it is fully possible to build electronic circuits that are controlled by a heat signal. Click here to read the published article.